How to maintain the wire saw? It is important to remember these points:
1. Check the cable of the wire saw cutting machine frequently. If it is damaged, it must be wrapped or replaced immediately to prevent leakage.
2. Clean the moisture and dust on the electric control box, body, and operating table of the remote control wire saw cutting machine regularly to keep the equipment clean.
3. Keep the inside of the control box dry. The diamond wire saw machine has been idle for a long time and should be wiped dry before use.
4. Before starting the wire saw cutting machine, check whether the main motor heat dissipation cover is normal to prevent affecting the heat dissipation of the main motor.
5. When the diamond beaded wire saw machine is sawing, pay attention to the waterproofing of the main motor heat dissipation port to prevent cooling water from entering the main motor through the heat dissipation port and causing a short circuit.
6. The operator of the concrete wire saw cutting machine must add lubricating oil to each lubrication point of the equipment every day.
7. Clean the guide rails and the intermediate feed rollers frequently and apply grease to prevent rust.
8. Regularly check whether the driving flywheel and the large leather ring of the guide wheel of the wire saw cutting machine are normal. If there is a large wear, it should be replaced in time, otherwise the beaded rope will wear abnormally.
9. The dirt on the equipment should be cleaned in time after each sawing operation, and the equipment should be thoroughly cleaned once a week to prevent the dirt from rusting the equipment.
10. Be careful when moving the operating table, do not pull the cable hard, and the operating table should be placed in a rainproof place.
11. The equipment is recommended to be used in the temperature range of 0°~35°.
12. During the cutting process, if abnormal sounds or abnormal conditions are found, the machine should be stopped immediately for inspection. It is recommended to maintain the wire saw cutting machine regularly.